DPCAV
POWER SUPPLY FILTER, L-C TYPE
This filter is used to reduce ripple noise and similar power supply nuisances. When used with power sources that have RFI/EMI noise problems we recommend that you also add Toroids filters on all the affected wires / cables. We offer popular sized Toroid (Ferrite) core filters that are ideal for RFI/EMI problems:Click Me!, Design Update: Beginning with September 2011 production, all PSF-001 filters are compatible with up to 5S LiPo batteries. Earlier production was limited to 3S applications. If you need to identify which voltage rating you have then check the printed voltage on the large 1000uF cap (capacitor); The older design used 16V caps where as the new design we now sell uses 25V rated caps., Note: Installations with severe power supply noise may not be fully cured with this filter. In such cases a shared battery should be avoided., Installation requires soldering in-series with the noisy power supply, as follows:, , Instructions:, Click Me!,
This compact supply filter helps clean up dirty DC power ...DPCAV
DIGITAL DC WATT METER / ANALYZER
| Instructions | Click Me! |
Features:, ,
The MX8120 is a handy digital meter for evaluating battery ...DPCAV
1.3GHZ A/V RECEIVER WITH COMTECH TUNER
| Four (4) RF channels | 1240MHz, 1280MHz, 1320MHz, 1360MHz. |
| Instruction Manual | Click Me! |
Important note: The DC input connector is a 2.1mm barrel style connector that is center (+) positive. Reversed voltages will damage the receiver..,
This 1.3GHz wireless A/V (audio/video) receiver is compatible with our ...DPCAV
900MHZ ANTENNA, V-DIPOLE
| Frequency Range | 880-980MHz |
| Gain | ~2dBi typical |
| Impedance | ~50 ohms |
| Polarization | Linear |
| RF Power | 10 watts maximum |
| Connector | SMA Plug (male) |
| Size | 4.6 inches (115mm) tip-tip length |
| Weight | 13 grams |
| Color | Green |
| Instructions | Click Me! |
Cable Length:, 10 inches (250mm) long,
This lightweight V-Dipole style antenna is designed specifically for 900MHz ...DPCAV
1.2GHZ - 1.3GHZ ANTENNA, V-DIPOLE
| Frequency Range | 1240-1320 MHz |
| Gain | ~2dBi typical |
| Impedance | ~50 ohms |
| Polarization | Linear |
| RF Power | 10 watts maximum |
| Connector | SMA Plug (male) |
| Size | 3.4 inches (87mm) tip-tip length |
| Weight | 13 grams |
| Color | Green |
| Instructions | Click Me! |
Cable Length:, 10 inches (250mm) long,
This lightweight V-Dipole style antenna is designed specifically for 1.2GHz ...DPCAV
900MHZ A/V RECEIVER WITH COMTECH TUNER
| Four (4) RF channels | 910MHz, 980MHz, 1010MHz, 1040MHz. |
| Instruction Manual | Click Me! |
The receiver requires a common 2.1mm barrel type DC power cord (available separately). We offer several different types and they can be found here:click here, half-wave dipole is a popular antenna choice and can be purchased with the receiver as an option. We offer other 900Mhz antennas too:click here., Important note: The DC input connector is a 2.1mm barrel style connector that is center (+) positive. Reversed voltages will damage the receiver.,
This 900MHz wireless A/V (audio/video) receiver is compatible with our ...DPCAV
5.8GHZ A/V TRANSMITTER, 200MW
,
SOLD OUT: No longer available. This 5.8GHz / 200mW wireless ...DPCAV
5.8GHZ CIRCULAR POLARIZED PATCH ANTENNA, +5DBI
| Note | Installations that require an RP-SMA connector will need adapter |
| Data sheet | not available. |
5.8Ghz Patch Antenna: This four element Patch Array antenna has approximately 5dBi of gain, 45° beamwidth, and RHCP circular polarization. But don't let its low price fool you -- it is a very good performer. We've found that it is an excellent receiver antenna in 5.8GHz FPV installations that are using a, Important: Do NOT paint or directly apply any covering materials to the antenna. You may place it inside a plastic enclosure that is rated as microwave safe, but we recommend that the front side have at least two inches spacing from the plastic surfaces to avoid reducing the antenna's performance.,
Cloverleaf circularly polarized antenna on the transmitter. Try it -- ...DPCAV
FPV POD PAN & TILT KIT FOR SKY SURFER / BIXLER
| Assembly manual | Click Me! |
| Manufacture's site | ReadyMadeRC |
The kit comes with two R/C servos, so it is a fantastic value. The provided camera mounting plate will fit many popular CCD cameras including:, DPC-171, DPC-520S, KX131, KX171, KX191 and others. An optional back plate is available that converts this kit for use with the DPC-420A, DPC-480A, and DPC-540A OSD cameras (, The kit includes:, Laser cut plywood components, You'll need to supply:, Double sided servo tape, Note: The video transmitter, camera, and battery are not included. They are shown in the photos for reference only.,
This FPV Pod video camera pan/tilt kit is specifically designed ...DPCAV
LIPO BATTERY - 3.7VDC (1-CELL) / 1200MAH (FOR JYE SCOPE)
| ● Voltage | 3.7 VDC (nominal) |
| Capacity | 1200mAH |
| Construction | 1-cell with protection circuit |
| ● Power Cable | 2-pin connector |
| ● Weight | 22 grams |
| ● Size | 2.40 x 1.5 x 0.15 inches (60 x 36 x 5 mm) |
| Safety Instructions | Click Me! |
Specifications:, , IMPORTANT: All LiPO chemistry batteries require a compatible charger for safe use. Never charge while unattended. Do not discharge below 3V per cell or charge higher than 4.20V per cell. Always follow the manufacturer's instructions., IMPORTANT NOTICE:, Due to recent changes in airline safety batteries are no longer allowed on international shipments. This includes APO, FPO, and DPO military base deliveries. If your order needs to be shipped outside the USA continent then please do NOT add any batteries to your shopping cart. We are still able to ship to USA destinations. For a full explanation please see this advisory:, Postal Publication 52,
Replacement rechargeable LiPO battery for JYE Digital Oscilloscopes. Compatible with ...DPCAV
1.3GHZ A/V RECEIVER WITH COMTECH TUNER (1258MHZ COMPATIBLE)
| Four (4) RF channels | 1258MHz, 1280MHz, 1320MHz, 1360MHz. |
| Instruction Manual | Click Me! |
Important note: The DC input connector is a 2.1mm barrel style connector that is center (+) positive. Reversed voltages will damage the receiver.,
New for 2013! The RX1258-CTS is a four-channel wireless A/V ...DPCAV
1.20GHZ ANTENNA, +7DBI (1200MHZ)
| Frequency Range | 1160-1240 MHz |
| RF Gain | +7dBi |
| Type | Omni-directional coaxial sleeve dipole |
| Polarization | Linear |
| Horizontal beam width | 360° |
| Vertical beam width | 26° |
| Input Power | 20 watts max. |
| Length | 14.5 inches (37cm) |
| Weight | 43 grams |
| Data Sheet | Not Available. |
DPCAV
5.8GHZ AUDIO/VIDEO TRANSMITTER, 600MW
| Frequency | 5.8GHz RF band. |
| RF Power | 600mW, +28dBm |
| RF Port | 50 ohms. |
| Channels | Seven (5740, 5760, 5780, 5800, 5820, 5840, 5860 MHz). |
| Video Input | Composite NTSC / PAL, 75 ohms. |
| Audio Mode | Stereo (left / right channels). |
| Audio Sub-carrier | 6.0 / 6.5 MHz |
| Audio Input | 1V Line Level, >10K ohms. |
| Antenna Connector | SMA type. |
| Operating Voltage | 7 - 25 VDC |
| Accessory Voltage | 5.0VDC output / 300mA maximum. |
| Weight | 25 grams (with antenna). |
| Size | 50 x 23 x 11mm. |
New for 2012:, Smaller Size, wider operating voltage., This transmitter is compatible with 5.8GHz A/V receivers offered by ImmersionRC, Airwave, and FatShark. Here's a list of popular receivers that we offer:, , Features and Specifications:, , Important:, , Notice: This is a ham radio hobby type product. Using the TX-5G8-600 in the USA and most other countries will require an Amateur Radio license. Some countries may forbid its use. It is your responsibility to ensure that its use meets the requirements imposed by your government’s RF spectrum regulations. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them., Frequency Summary List:, , Instruction Manual:, Click Me!,
The TX-5G8-600 5.8GHz 600mW A/V transmitter packs a powerful punch ...